|
|
|
|
Introducing more new products !
IPS-12v Intelligent Power Stabilizer Intelligent Power Stabilizer (IPS) is an active power conditioner for critical aircraft loads such as GPS and EFIS systems. The technology utilized in IPS-12v allows aircraft electronics to be powered and operational prior to, and during engine start. IPS saves Fuel and Operating cost by allowing GPS flight planning and clearance changes to be completed with the engine off. IPS-12v provides power to GPS and EFIS systems free from voltage surges and sags allowing these systems to be powered directly from the main aircraft bus without the need for auxiliary batteries. Additionally, the power converter technology in IPS provides additional run time to critical loads during alternator out conditions.
(click on picture for a larger view)
Learn all about IPS-12v (click here) ILC-4ch Intelligent Lighting Controller Intelligent Lighting Controller (ILC) is an electronic control system specifically designed for switching and dimming lighting loads in an experimental category aircraft. ILC provides independent control of up to 4 lighting circuits, such as landing , taxi , strobe and navigation lights. Additionally, 3 independent dimming circuits may be controlled. ILC also includes a wig-wag function between 2 of the lighting circuits. The ILC remote power module connects to the switching panel via a low current multi-conductor cable. This configuration greatly reduces wiring density behind the aircraft instrument panel.
(click on picture for a larger view)
Learn all about ILC-4ch (click here) IFC-1 Intelligent Flap Controller Intelligent Flap Controller (IFC) is an electronic controller designed specifically to operate DC motor actuators such as the Van’s Aircraft series of Flap Actuators used in RV type homebuilt aircraft. IFC connects to the standard up-off-(down) switches commonly used to control flap operation and directly drives a Van’s flap actuator. IFC allows for Pilot and Co-pilot flap switches and resolves the possible conflicts if the switches are operated in opposite directions. IFC requires NO flap position sensor and is fully compatible with Safety-Trim servo controllers.
(click on picture for a larger view)
Learn all about IFC-1 (click here)
USW-1 Universal Switch- Airspeed kit Universal switch airspeed kit (USW-1) includes an ASW-1 airspeed switch and a Universal Switch-SPDT controller. This combination of components allows for the switching of electrical loads up to 10 amps and up to 30 volts based on aircraft speed. (click on picture for a larger view) Learn all about USW-1 (click here)
Safety-Trim Intelligent Servo Controller Safety-Trim is an electronic speed control system for standard electric trim servos found on many homebuilt aircraft. It replaces other speed controllers and relay modules with an electronic solution that resolves issues such as run-away trim and failure to operate conditions. Safety-Trim greatly simplifies trim switch wiring, especially when installing pilot and co-pilot switches. Additionally, Safety-Trim provides high speed and low speed trim actuation based on airspeed.
(click on picture for a larger view)
Learn all about Safety-Trim (click here)
|
|
Send mail to webmaster@tcwtech.com
with questions or comments about this web site.
|
