Intelligent products, engineered to be smarter


 

Home
BACK

 

 

Text Box: The Intelligent Power Stabilizer, IPS, is an electronic power converter for critical electrical equipment found in general aviation aircraft.   IPS provides aircraft bus voltage surge and sag protection for the connected electrical equipment.   The IPS system will operate over an input voltage range from 5 volts to 15 volts and provides a regulated output voltage of greater than 11.25 volts.    The IPS system allows electronic equipment such as engine monitors, EFIS and GPS’s to be operational before and during engine starting.   This important feature allows the pilot to load flight plan data into the aircraft GPS prior to starting the engine thereby saving fuel and operating expense.   When used with aircraft engine monitors it ensures the pilot can monitor critical engine operating parameters such as oil pressure during the engine starting process. The electronic power converter in the IPS system ensures the connected electronic equipment is provided with a stabilized source of power even when the aircraft battery voltage drops significantly.   This is particularly important during engine starting or alternator out conditions.   IPS additionally provides surge protection by actively clamping the regulated output voltage. The IPS-12v-4a model features a panel mounted low voltage warning light which may be used to provide a pilot warning when the aircraft bus voltage falls below 12 volts.           

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The IPS system is available in 2 models:

IPS-12v-4a  rated for up to 4 amps of output current

IPS-12v-8a  rated for up to 8 amps of output current   

             

 

Download the actual product installation manuals :

  IPS Installation Manual

 

On-line ordering:            ground shipping in USA included !

Solution Graphics

Intelligent Power Stabilizer  4 amp  IPS-12v-4a   $295      

Intelligent Power Stabilizer  8 amp   IPS-12v-8a  $365      

 

        

 

 

 

 

Text Box:   SPECIFICATIONS:     Input Voltage:             5-15 volts DC,   Output Voltag            >11.25 volts DC   Converter:                 True DC:DC converter with output over voltage,                                                 over current and over temperature protection   Panel warning light:          IPS-12v-4a only model, preset to 12.0 volts   Surge Protection:              16 volt active clamp, 1500w 10/1000uS waveform   Wiring:                                  IPS-12v-8a : insulated barrier strip, #6 screws                                               IPS-12v-4a : 4ft leads,  Mil-spec wire   Enclosure:                           Cast aluminum     IPS-12v-8a : 4.6” x 3.7” x 1.18”          IPS-12v-4a : 4.39” x 2.34” x 1.06”    Weight:                                 IPS-12v-8a : 14 oz.                                                 IPS-12v-4a : 8 oz.   Temperature range:             -25 C to 60 C        

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Send mail to webmaster@tcwtech.com with questions or comments about this web site.
Copyright © 2007,2008 TCW Technologies LLC.
Last modified:10-25-08